Flechtkorb - Wickerwork basket

Good results without any support-structures. Print needs 25h with a Creality Ender 3 S1 Pro and 60mm speed (via Klipper). Because of the enormous number of edges, you should do some fine-tuning in optimizing the speed at corners and the flow control.

In the pictures of the printed basket, you can see an extra corner. This was a test print to check if you can print without support. The basket is in one piece, and you don't have to join any parts.

Update

2023-12-19

Variants have been added in which the base has no holes. Check the extra folder.

2023-09-27

Added a smaller basket (~ 131 mm * 92 mm, height = 42 mm) with the same design and same braid size. So this is not only a shrunk version, it's a beautiful addition to the big basket.