Paw Patrol Alexa Dot Gen 2 Holder

This is my Alexa Dot Gen 2 Paw Patrol holder I created for my lil Paw Patrol Fan in my house. All the files are here and you can use the height changes for easy filament changes in your slicer software. The name file was removed since not everyone is named Connor lol open any cad program (like tinkercad) and add text to it yourself if you want to.

Only the bottom base and back holder need supports, the rest will print fine without supports.

The top telescope part of the Paw Patrol tower was to small to print  so I cut it off and I used a small yellow paper clip, but a small piece of filament will work too.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

.2

Infill:

20%

Once you finish printing everything, just super glue it all together. It is easier if you run the cable through the base first then connect the plug to the alexa dot gen 2 then slide the whole thing into the holder. It is a tight fit so be careful when sliding the dot into the holder as you may pop the front face disk off if you push to hard.