Travel Pill Case

Never know when you'll need a pain reliever, tum, or what have you. Sometimes it is inconvenient to keep a whole bottle on your person when you will most likely only need two tablets of whatever at the time. That's why I made this container, it is minimalistic and is a must have on your desk at work. These antacids are not name brand and are a bit smaller than normal ones (I think, I don't have any actual TUMs to compare). These are from a brand called "equate", and are easily found at Walmart. Everything else is pretty standard though.

I will be looking to remake this in the near future with a hinge so that the lid does not slide off. This would make is so you don't have to be so careful putting it in your pocket.

Print Settings

Printer:

Homebrew Monstrosity

Rafts:

No

Supports:

No

Resolution:

0.2 mm

Infill:

20%??? Do whatevs

Notes:

If tolerances are tight, just print both the lid and holder at a slightly larger size (e.g. 101%). Those who have printers with high accuracy should have no issue.

Post-Printing =============

Attaching the Magnets

This is intended to be used with small 3mm diameter x 1.5mm deep neodymium magnets, which can be purchased cheap just about anywhere. Just use some super glue to hold 'em in place.
I got mine here, which are uncommon on their website because it is a bulk surplus purchase, and they usually have imperial measurements only.

1/8" x 1/16" is the closest imperial equivalent and should also work, may be a bit of a tighter squeeze but the tolerance of the hole diameter should still be good enough for that. So for anyone looking to make a smaller and cheaper order with imperial magnets, try this link http://www.kjmagnetics.com/proddetail.asp?prod=D21

Category: Organization