Lack v2 Top Vent

Top Lid Vent for Lack Enclosure v2 with MMU2s for better ventilation when printing PLA. Also good for directly feeding filament to the printer - for that time of the month when your MMU2/s is busy contemplating the meaning of life (just kidding mine works fine, it was quite a journey though).

Print instructions

I printed it with Prusament PETG to colormatch my printer, but any PLA should do. Besides the printed parts you need a bit of super glue, 4x M3 nuts and 4x M3x10 screws.

Mounting instructions:

1. Remove the Lid and put it on a stable surface. put a Square hole in it with a jigsaw or something similar, for dimensions see the picture. With an opened vent the cuts will be visible so don't be me and at least try to make a clean and exact cut ;)
2. Affix the upper part with masking tape and drill through the screwholes with a 3mm drill.
3. Put the nuts into the holes of the lower part (as always, use a bit of masking tape if they tend to fall out).
4. Put the upper part and the sliding door on top and hold the lower part while tightening the screws. Done!