EDF Housing for 64mm blades (64 / 64.5 / 65mm internal diamention)

EDF printed because the original one was a little bit too small

Internal dimension is 65mm instead of 64 to prevent rubbing but I see some space between wall and propeller, so I think it can be lowered about 0.5 and still fit without rubbing but I didn't tested. This dimensions are good enought for me, so I upload the photos of my 65mm and also stl files for 64.5 and 64mm if someone need ultra fine fit.
If You decided to print smaller one please leave an information for others how it works

outer diameter = inner + 4mm (2x 2mm wall)
hooks: 3.5mm x 0.8mm (for best print with 0.4 nozzle)
mounting wholes: 4x 3mm on 8mm radius
(this is my model: https://s.click.aliexpress.com/e/_Evp1SiX )

Used material: PLA Impact - Fiberlogy
Layer height: 0.12 mm
100% infill from walls