Adjusted them a bit to fit the thicker Ikea plates of which I had a 20x100cm cut off laying around.
Printed in petg w/o supports
Monitor Riser 100mm - IKEA JÄRPEN
Found some old shelf boards and had to make use of them :) So I designed two pillars to lift it up. On each side it…
140
344
4
2571
updated February 21, 2021
Makes
Comments
Used some spare wood planks I had lying around, great addition to my desk. Finally I can just park the keyboard under it.
I had to scale them down a bit to fit the PrusaMINI printbed. But printed just fine and very easy. Thanks for the design
