RC Plane (Ardupilot Flying Plank / Flying Wing)

My video about this project:

Parts used in this project:

• 1x Mateksys F405-SE Flight Controller
• 2x Emax RS2205 2300KV Brushless Motor 
• 2x LittleBee-Spring 30A ESC
• 2x 5045 propellers
• 2x MG-90S Servo 
• 1x 5V BEC for Servos
• 1x BN-880 or Holybro M8 5883 GPS and Compass module
• 1x ExpressLRS EP1 RX
• 1x 3S 3000mah Li-ion battery pack 
• 2x 200mm Push Rods
• 1x Carbon Rod 5mm x 1000mm
• 2x X Type Cross Holder for Brushless Motor(Mounting holes need to be drilled to 4mm)
• 5mm XPS Foam Sheets
• M3 imbus screws 
• Tape
• Hot Glue

Here are the ArduPlane parameters I changed in addition to those I talked about in the video: