Gargoyle Pipe Cap

Designed to snugly fit over an 18mm outside diameter pipe, a decorative way to keep wasps from nesting inside the pipe.
13
87
0
765
updated February 21, 2021

Description

PDF

This is a remix of Misterdid's gargoyle on Thingiverse (https://www.thingiverse.com/thing:2471156), designed to snugly fit over an 18mm outside diameter pipe. It has a small hole in the bottom of the tube for a grub screw to further secure it to the pipe. Intended as a decorative way to keep wasps from nesting inside the pipe. :-)

Print Settings

Printer Brand: SeeMeCNC

Printer: Rostock MAX v2

Rafts: No

Supports: Yes

Resolution: 0.3 mm layer height, 0.6mm width

Infill: 10%

 

Notes:

I did a fair amount of sculpting in Meshmixer to minimize overhangs when printed horizontally. Support is still needed up to the mouth, however.

 

 

 

Category: Decor

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License


Highlighted models from creator

View more