Frameless hanger for art cards and prints

Inspired by anoved's Frameless Hanger for 3/16" Foam Core (https://www.thingiverse.com/thing:963747), this is a miniature version for 1mm or less thick art cards and art prints. Print 4 corners, tie them together with string, and use to hang the cards.

I've included the OpenSCAD file used to create these, but note it is not parametric - any changes you make will likely require further tweaks to make everything work out.

Important: Do not put pressure on the loops when tying the string, they are liable to break off, and the cardstock will deform under tension anyway.

Print Settings

Printer Brand: SeeMeCNC

Printer: Rostock MAX v2

Rafts: No

Supports: No

Resolution: 0.3

Infill: 100%

Notes:

Print these vertically without support. I used a skirt to help hold the objects to the bed and that worked fine. A full brim that includes the interior area requires too much post-processing clean-up.

Category: Art Tools