This was created out of frustration with the typical test lead holder that uses fingers, the test leads would fall off and it would take a while to figure out what was available from the rats nest underneath. This has resolved my issues and puts a smile on my face when I need to run a test.
You can mount this with wall anchors or adhesive just keep in mind that it can get quite heavy fully loaded.
Printed with PLA, .4mm nozzle, .2mm layer height, 4 vertical and horizontal shells with 15% Gyroid infill.
The anchor model is from McMaster item # 66615A21, it's designed for a #8 screw but a #6 should work as well.
No supports required!
Models import in the intended printing position.
MMU - There are two models for different colors - bananaTestLeadHolder_MMU_base and bananaTestLeadHolder_MMU_top.
Non-MMU - There is one model - bananaTestLeadHolder_manualSwap.
The author hasn't provided the model origin yet.