A tiny screwdriver, storing seven 4mm Micro Bits (28mm in length) and attachable to a keyring or string on your gear. → Be prepared for that single or few screws that casually pop up, trying to ruin your day.
The forces induced by the applied torque are spread over a large area by the stored bits, stripping a screw is no problem with this design.
Recommended for printing is a 0.2 mm layer height and a 0.4mm nozzle or finer. The version in the pictures is printed with these settings in PETG. With that material adequate cooling is advised, I simply printed a set of two to give the small layers enought time to cool.
There may be improvements, modifications and deletions based on feedback given here.
Maybe, take a look at my other designs ;-)
The author marked this model as their own original creation.