I needed only the axis, because the Prusa spool is only wider. Also the bigger frame didn't fit my printer bed.
Donor Spool Holder Frame for 2kg+ Spools
Larger, taller, wider Frame for 2kg-6kg spools uses longer axle, but same nut.
26
211
2
885
updated
December 31, 2023
Makes
Comments
Thank you for publishing this. Could you please provide a version that fits a 24x24 cm build plate, like Bambulab XC1 has e.g? It misses by just a few millimeters. I would highly appreciate it. :)
@jaddel_129816 Just cut one of the ends off using prusa Slicer, its what I did. You may lose screw holes on one end, but I do not use them anyway. (I use 3M double sided tape to hold it down).
@jaddel_129816 I dont have a Bambu, and I dont understand how this is being used in the application you mention. I use it to respool large 6kg Bulk spools (Cheaper filament) onto usable common 1kg Spools. More information and I can likely help you out.
View one more comment