Snowman with box

This is a realistic friendly little snowman busy carying a box. The body looks like a real snowman shaped by hand. The object is hollow so it does not use much filament. Heigth without hat is 9.5 cm (3.7 inches). Weight with hat approx. 43 g. Glue is needed for the final assembly.

You can put small items into the box, e. g. your precious finger rings, micro SD cards etc.

You can print your snowman without the hat and decide later, if you would like to print and glue the hat not.

See also my snowman without the box:

https://www.thingiverse.com/thing:5740920

List of items to print:

• Snowman V2.stl

Snowman body with the 3 balls. Print once in white color.

• Box V1.stl

Print this item once in any color you like.

• Arm left V2.stl, Arm right V2.stl

Print once in brown (= wood) color.

• Eye V2.stl

Print twice in black color.

• Mouth V2.stl

Print once in black color.

• Button V2.stl

Print once in black color.

• Nose V2.stl

Print once in orange color.

• Hat back V2.stl, Hat front V2.stl

Print once in black color. The hat is divided into 2 parts to avoid supports. Glue the parts together after the print.

Enjoy printing this object.

Print Settings

Printer:

FLSUN Super Racer

Rafts:

No

Supports:

No

Resolution:

0.2 mm initial layer, 0.2 mm layer height

Infill:

20 %

Filament:

White, black, new brown, orange, green Post-Printing =============

Glue the eyes and nose into the holes designed for them. Add the mouth to your liking under the nose. Glue the single button into the inset on the lower ball. Glue the arms into the holes of the middle ball. Glue the box to the middle ball.

You can have your snowman without or with the hat. If you prefer the hat, glue it in some slope onto the top ball.

How I Designed This

This object was designed with Blender.