Artillery Sidewinder X1 Reverse Bowden Mod

Notes

With the original extruder PTFE tube does not have hard attachment on the extruder side so with long retractions it can become loose. Nothing bad, but better to have short retractions (below 2mm).
 

BoM

• Attachment to the chassis:
  • 2 x M3 T-nut
  • 2 x M3-8 screw
• Filament sensor attachment (one of the variants):
  • 2 x M2.5 insert + 2 x M2.5-16 screw
  • 2 x M3-18 screw (screwed directly to plastic)
• 1 or 2 x M6 PTFE fitting
• PTFE tube:
  • From extruder to the cradle - 50cm
  • From cradle to the spool - depending on the spool positioning

Printing Details

• Color: Any
• Material: PLA
• Nozzle Diameter: 0.4mm
• Layer Height: 0.2mm
• Infill: 20%
• Number Of Walls: 4
• Supports: No
• Print on side