Prusa XL series: PTFE guide support

I had a lot of trouble inserting filament over the PTFE tube because it allways get stuck an the Extruder. Not anymore ! My adapter helps to straighten the last 2 cm of the ptfe tube to the Extruder. This helpfs to guide the Filament in a straight way.

Please print as fine as possible, i used a 0.25mm nozzle with an (overkill) 0,05mm layer height

Have fun!

After many asked me how they could support me, you can now 

Tip me on KO-FI by klicking here:

                                                      https://ko-fi.com/surfalex2000

Check out my other optimized XL Parts! There is a Series to come!

You can find them in my Collection:
https://www.printables.com/@Surfalex2000/collections/830114