Pandaplacer Y gantry fan shroud
This is a fan shroud that is used to cool down the X axis stepper stick.
It uses a 4010 24v blower fan.
2
22
0
170
updated September 1, 2023
Description
PDFFreeCAD source included.
Installation is simple:
- slide the fan inside, with the wire oriented toward the cut
- slide the shroud over the motor
You'll have to use the 24v/gnd from the stepper stick pins on the back of the PCB. (lower right corner, check the silkscreen for pinout)
A right angle pin header works fine.
Tags
Model origin
The author marked this model as their own original creation.
