Ikea Skadis Wera 950 Hex Plus (1,5-5mm) keys magnetic mount

I needed only the small Wera Hex keys from 1,5 up to 5mm. So I remixed the model by jcq. Furthermore I had not the described magnets and thus had to adjust the magnets holes to 8x3mm an 5x2mm. Finally the hooks did not fit through my SKADIS holes (maybe due to tolerances when printing or because I used pets not ABS. ABS shrinks more than PETG).

So I chamfered the edges and slimmed down the hooks a bit for a better fit in my SKADIS board.

Thank you  jcq for the idea and the original model.

Material needed:

• 6x magnets round 8x3mm
• 6x Magnet round 5x2mm

Please show me your results and send me fotos of your makes. I like to see how you use this model. If you have ideas for improvement don’t hesitate to send them to me in the comments.   I will try to incorporate your suggestions and will modify the model for special needs if you ask me to do so. 
And of course a like ♥ or a rating ⭐ of the design are always welcome. 

happy printing, clamikra