Toothbrush Travel Case - Print in Place (the cutest one)

Intro

Welcome! This is a very cute and stable looking travel case for toothbrushes. Your wife or girlfriend will love it!

It's printed in place with a hinge. There are two different sizes for download at the moment. S for Dr. Best toothbrushes and similar. For larger brushes, you can download M. Should this also be too small for your toothbrush, send me a message and i will create another one.

Print settings recommendation

Layer height: 0.2mm
Line width: 0.4mm
Cooling: 40-80%
Minimum layer time: 5s
Speed: 40mm/s

PLA should be sufficient and easiest to print, but you can try other filament types too. Print orientation is the heart embossing on the print bed. The heart is left out for the first layer and gets closed in layer 2 and subsequent.

This case is designed to fit tight, the hinge as well as the closure. Be sure to have your clearing tolerances dialed in perfectly! If not, try to increase cooling to 100%.

Make sure the Toothbrush is dry before putting into the case. If there are request for a ventialted version of the case, i will open the heart embossing completely for the toothbrush to be able to dry. Send me a message, if you would like me to create such a version.