Vanagon VintageAir AC Duct Replacement

This is for the Gen 4 Smallcar AC dash kit. 

I didn't like the way that the air vents for the dash were hard up against the brake booster, and the subsequent super tight curves required.

I have the large BMW booster, so its probably better with the OEM one, but this makes for a much nicer curve on the hoses without any deformation.

Print in ABS or ASA for temperature handling ability.

While possible to print in one piece, that uses WAY too much support material, so I printed it as separate pieces and use JB weld to attach them together. the fit is tight, so you'll probably need to sand the 90 degree ducts a little to get them to mate tightly.