Vertical Paper Towel Holder (Wall Mounted)

I designed a paper towel holder for a small nook in our bathroom.  There are two Towel Rods with different diameters depending on the tolerance of your printer:  one is 29mm and one is 30mm.  The recess for the Rod in the Base is 31mm.  I used epoxy to bond the two parts together.  This will fit a jumbo 6 inch diameter roll.

September 19, 2024:  Added a 30mm rod that accepts screws.  I used M3 screws, but you could tap the holes for M4.

0.6mm nozzle, 0.3mm layer, PLA, Sovol SV01