x6 Needle File Pegboard Holder

I really liked the Needle File Pegboard Holder by andrewsworkshop but there was one tiny problem with it; the description lists it as accommodating a set of six(6) needle files and the design has five(5) holes. So I remixed it to have six.

I used tinkercad and "eyeballed" the spacing, for the most part. It seems relatively even but may not be exact, as I'm a bit of a 3d modeling n00b, ¯\(ツ)/¯.

If you're looking to remix my remix, have at it:
https://www.tinkercad.com/things/fMsEhpofrm2-needle-file-pegboard-holder-x6

Print instructions

Print Settings

Printer Brand: TEVO

Printer: Tarantula

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 20%

Filament:
AIO Robotics PLA Red

Notes:

I could have gone faster (I printed at 40mm/s), but was worried about the upper peg hooks, which could have just had supports, which I failed to use. I cut off noodle or two of spaghetti from the underside of the hooks and it works quite stably on my pegboard.