Headphones Holder (fits 20mm table thickness)

I needed a place to put my headphones while not in use when I sit at the dining room table. I gotta come out of the cave some time, and a guy's gotta have a place to hang his headphones.

I have a farm-style table with a 20mm thick top that has a 20mm roundover on the edge. The clamp on the holder is only a friction fit. It doesn't need to be more than that, the Soundcore Space Q45 headphones I have, for which the hook of the holder is intended, are very light, so a friction fit is fine. The hook on the holder has a 24mm depth to fit the 23mm band of the headphones.

I printed in PETG on a Bambu Lab X1C, 0.2mm LH, 4 walls, 25% infill, supports (snug), and (important for easy support removal) Top Support Interface Layers and Bottom Support Interface Layers both set to 0 (zero). The latter setting will give you supports that are almost magically easy to remove (just squeeze the support walls together and it'll pop off almost perfectly clean with minimal cleanup). 

Happy printing, and remember: depending on your printer and settings, your mileage may vary.