Cable Channel / Duct with different corners

Update 2024-06-23

Added 3 new corners

Update 2024-01-02

Added T-junctions and an end piece

I designed the cable channel to cover the 4 Atmos cables running from my ceiling to the AV receiver.

The space for the cables inside is 20 x 10,5 mm.

The idea was to clip the long channels into the wall pieces on the end, so each wall piece is covered by 2 channels.

I also designed some corners, I think with flipping and mirroring in your slicer you can have all the corners you want, if you need something special, just write me a short message and I see what I can do ^^

Printing

I printed the channels with the flat side on the print bed, some of the corners need supports.

I could fit 5 channels on one Bambu printbed (see last pic)