Disney Lorcana Deck Box - Sleeved Variant

Update - 07/09/23

Yet another tweak, whilst sleeved cards did fit in the deck box they were a little tight around the lid, I have now fixed this issue :)

UPDATE - 06/09/23

I have tweaked tolerances on a couple of the parts so the logo and centre piece now just click and hold into place - Superglue not required if you prefer not to use it 

UPDATE - 05/09/23

Following further feedback - the tolerances were fixed and the lid was too loose - I have added some lugs and holes to prevent the base from falling out. This has been printed in full and tested thoroughly, a lot of jostling with cards inside and holding by the lid will cause the base to fall out but otherwise its a pretty decent solution, even if I do say so myself. I've included a .gif of the test.

Additional Materials:

• Super Glue
• 6mm x 2mm Magnets - (Strongest N52 Magnets Strong Various Size 2-30mm DIY, Craft,Small Disc Magnet, | eBay) - You will need a minimum of 4, a maximum of 8.

Instructions:

You will need to print the parts with supports, organic would be preferable but whatever you can get to work.

The Logo needs to be glued into the lid and the logo centre into the logo. You will also need to glue the magnets into the base and the Ink Symbols. 

The box itself is design as a push fit type box so no hinges or anything to contend with.

IMPORTANT

I'm currently waiting for my magnets to arrive so that I can print and test - Please let me know if there's anything I can do better/Improvements that need to be made.