Shorter Door Seal for P1S

I liked the door seal created by Jia gantic but it did not fit right on my P1S - it would bind in the hinge if the door was fully opened.

This remix cuts 0.8mm off the top of it and brought the legs closer together at the bottom for a tighter fit.  It still fully seals on the edge but no longer binds for me…

I also uploaded a 1mm cut version BUT have not tested this version.

If this is still binding, you could try scaling the Z axis to 90 or 95%…

Equipment/settings:

• P1S
• Bambu slicer
• 0.4 nozzle
• Black PolyMaker PolyFlex 95a TPU 
• Default generic TPU profile with retraction tweaks 
  • 2mm retraction
  • 45mm/s retract
  • 20mm/s deretraction
  • 1mm distance threshold
• Printed in silent mode
• Bambu gold textured PEI plate with glue stick

Sorry for the bad photo - photographing these black filaments on a black printer is tricky…