I didn't like Nevermore because it's pretty hard to print with ABS without any warpping, so I wanted to use The Filter in my VORON 0.2. I designed a mount that's quite easy to attach to the 1515 extrusions and allows to get the filter out to change the active carbon.
Mouting to the frame requires 2 nuts, you can either use LDO drop-in nuts or have 2 preloaded nuts (less likely since it needs to be done early in the frame assembly).
The mount was designed to have a female JST XH connector for quick and easy connect/disconnect.
The Filter was designed to improve heat up time on a VORON 2.4 but with this single fan version I didn't notice any improvement in heat up time, but technically it should help by circulating the hot air to the bottom of the enclosure.
I would strongly recommend to test the wiring and the fan before installing.
The author remixed this model.
Modified version of the filter with magnet holes
Original V0.2 mount