Gummy Knob for Prusa MK3

Bring yourself back to excitement of the early days, when you were first assembling your printer with the Gummy Knob for Prusa MK3 v1.0. Designed by our engineers using only the finest sources of Gummy Bears and Knobs, our Gummy Knob will spark joy for years to come. 

FAQ:

Q: Does it function well as a knob?
A: While spinning the gummy knob may require a bit of practice for those more experienced with traditionally designed knobs, the gummy knob offers a number of engagement points, allowing for a wide variety of manipulative techniques.

Q: How much infill should I use?
A: I used 10%, but that's because it was set as the default of the profile I was using, and the two clicks needed to change it seemed like a lot of work. Unless you push buttons very hard, you could probably print without infill at all.

Q: Don't you think it should be bigger/smaller/fatter/thinner/wearing-a-party-hat ?
A: Yes! That's why we offer access to our complex source model at no additional cost.