Kitchen wall SPONGES HOLDER [special hook]

Special and elegant holder for different sponges for dishwashing to keep them off the surface. Modelled in parts for easy printing and for easy washing out.

• Main desk which is hooked into the kitchen wall /special hook into the built-in aluminium bar
• 6 Screwed nobs which screw into the main desk's plate
• Top floor for a napkin, wipe or similar cloth with the width up to 18cm
• Middle shelf to hold sponges or a scourer, with holes in the bottom
• Bottom shelf to hold anything more or used as a container for a dropped watter from above shelf.

Print:

• Main desk: front side down for a nice clean surface. Add organic supports for the build plate for the screw holes. You can exclude the hook part. 10% infill is ok, you can play with higher infill around the drilled holes (add 6 respective cylinder modifiers positioned at the holes and with a slightly higher diameter, infill 40-70% for firmer part when screwing the nobs into them.
• 6 nobs: Position screw part down, add organic supports on a build plate only. Ideally 0.20 or 0.15 layer height for smooth functionality, 100% infill for firmness.
• Top holder (the “arms”): Any position, higher infill (40-70%).
• Middle shelf: print on the side with organic supports, 10% infill.  
• Bottom shelf: print on the side with organic supports, 10% infill.

Assembly:

1. print all parts, remove supports
2. screw the 6 nobs into the main desk. You can use a screwdriver or other tool to help you screw parts in (CAREFULLY THOUGH!). Tip: use a bit of oil on both parts and play a bit with them when screwing in. Note: if the screw isn't aligned fully with the plate it is ok, do not overtighten!
3. slide in the top, middle and bottom holder.

Printed with:

Nozzle: 0.4 

Default Layer Height: 0.30

Default Infill: 10%.

Printed with: Prusa MK4, Prusament PLA Galaxy Black

Print times: 

• Main desk: 4h14m
• 6 nobs: 55m
• Top holder: 2h8m
• Middle shelf: 6h36m
• Bottom shelf: 2h25m