Neco Arc

Ever wanted to print your own Neco Arc but have found that models available will not survive printing at all? Well, now there is one that most likely wont snap as long as your print settings are correct.

My Neco Arc was printed on my Prusa i3-mk3s+ with a .6mm nozzle and .4mm layer height as a 10cm statue.

I recommend printing it as a print no shorter than 10cm with any layer height, with atleast 2 or 3 perimeter walls, a minimum of 5% infill or more and with organic supports or similiar depending on your slicer.

Brim is also recommended but not forced if your bed adhesion is okay.

Happy printing!