Edge Pro Magnet Accessory - Retractable

This is a retractable magnet accessory for your Edge Pro Apex sharpening system.

The magnet accessory can be

Parts:

1 x Neodymium magnet 20x20x10mm size.

1 x M4 Brass insert

1 x M4 (10mm long) Thumb screw or normal screw (It is used as a handle to retract the magnet accessory and to push it back up when needed.)

Steps:

1- Print the part.

2- Epoxy glue your magnet into the slot in the printed part.

3- Melt your M4 Brass insert into the hole, and install your M4 thumb screw / M4 screw.

4- Remove the screws, nuts and washers of the legs of your Edge Pro Apex.

5- Install the part with the magnet facing down into the slot between the legs of the Edge Pro.

6- Re-install the legs of your Edge Pro Apex with the original screws, nuts and washers.

When you want to have the Edge Pro table magnetised, simply push the magnet accessory up, and when you want to use it without the magnet, simply pull the magnet accessory down. The Edge Pro legs screws are used as stops so you can't pull the accessory out all the way.

If you find my designs useful, please go ahead and click on "Tip Designer" to the right of the photos at the top of this page. Proceeds will be used to purchase printing filament so I can keep designing and testing cool new things that you might find useful.

Thank you!

NOTE:

Some of my other useful designs:

https://www.thingiverse.com/leadingedge/designs

Print Settings

Resolution:

0.2

Infill:

30%

Filament: PLA or PETG PLA or PETG

Notes:

If you like my designs, please send me a tip (link below) so I can keep designing awesome accessories for free. I use any money sent to me for purchasing filament to test my designs so I can make sure they are good to go.