Tesla Cyber Truck

This is a model of the Tesla Cybertruck!

Print instructions

PARTS:

Printed:
1x Main Body - ideally silver, supports required
1x Lower Body - ideally black, supports required
1x Wind Shield - Black
2x Side windows - Black, Make sure these are mirrored
4x Wheels - Black
4x Wheel Caps - Black

Other Mechanical:
6x m3 threaded inserts - amazon link
6x m3 by 8mm - amazon link
4x m4 screw, at least 8mm - amazon link

Other Tools/Materials:
Super Glue - used for windows wheel caps
Hex Driver 2.5mm
Philips Head Screw Driver
Soldering Iron

Assembly Steps:

Step 1: Once all items are printed make sure to clear off all support material

Step 2: Preheat your soldering iron. Place all inserts above their holes(all holes are on the top piece, the silver one). One by one heat them up and push them in paying special attention to keep them straight.

Step 3: Screw on the bottom plate to the top piece using the m3 screws. There should be six in total.

Step 4: Super glue the windows in place, make sure the build plate surface faces out for nicer looks(especially if you have a glass bed)

Step 5: Screw the wheels on using the philips head m4 screw. Make sure that all wheels can spin freely at this point.

Step 6: Super glue wheel caps into place - ensure that all wheels spin freely... there is no going back

Congrats, Your Done! Hope you enjoy!

DISCLAIMER: There is an Etsy Listing for this product, I am the owner and only one authorized to sell it.