IQaudio DAC Pro Case

This is remix of Stamos fantastic Hifiberry Case. 

The original model was modified as follows

• dimensions were adjusted to IQaudio DAC Pro High-Fidelity-Audio-Output-HAT 
• the case was extended in height to allow using the GPIO pins
• a hole for a M12 cable gland was added to feed a data cable into the case towards the GPIO pins, e.g. for connecting I2C modules like an OLED or for switching a relay.
• screw tabs were added to allow wall mounting

The case was designed and tested with a Raspberry Pi 3 Model B.

For the full assembly you need:

• the printed parts
• Raspberry Pi with SD Card and power adapter
• IQaudio DAC Pro
• 4x Nylon spacers (10 mm, M2.5)
• 4x Nylon nuts
• 4x M2.5 with 6 mm length metal screws
• M12 cable gland

The model on the pictures was printed with PLA (Prusament Galaxy Black) with 0.2 mm layer height and 4 perimeters.