The model these remix options are based was discussed here.
Friend and fellow V1 Engineering maker, Jonathan Jones, V1E username @Jonathjon, mentioned that the “Model still needs some refinement…” and specifically the wish to eliminate need of supports, and also, “Wish I could figure out how to get it turned 45° so it would face forward.”
These remixes address that.
Here are the meanings of the various version names:
2a-side: mounts the mist mixer box out toward the SIDE, and HAS countersunk areas for the heads of the mounting bolts.
2a-front: mounts the mist mixer box out toward the FRONT, and HAS countersunk areas for the heads of the mounting bolts.
2b-side: mounts the mist mixer box out toward the SIDE, and has NO countersunk areas for the heads of the mounting bolts. This version may also allow a choice of which side to mount the mist mixing box. Not sure…
2b-front: mounts the mist mixer box out toward the FRONT, and has NOT countersunk areas for the heads of the mounting bolts. This version may also allow a choice of which side to mount the mist mixing box. Not sure…
Print notes:
The model options here could be oriented for printing either as shown or rotated with the round part facing down. I felt the orientation shown would give the best strength regarding layer adhesion.
If your printer is a “bed-slinger” instead of a CoreXY, consider rotating the part by 45 degrees so its long edge is running from front to back, assuming you print oriented as shown. In case this suggestion is not clear, below are two images, the first with the models not rotated by 45 degrees (not recommended) and the second with them rotated by 45 degrees as suggested.
Pic - models not rotated by 45 degrees (not recommended):
Pic - models rotated by 45 degrees as suggested:
Usage notes:
The print orientation shown is upside-down from the orientation for use!