Ratrig Foot

1. Remove feet with Joining Plate for 3030 - 90 Degree (preferably each foot separately).
2. Reuse M5 and M6 screws and insert a M5 Hex Locking Nut through the largest hole in the intended stall.
3. Fix the Rubber foot with metal insert with M5 screw from the other side (fix it with a blunt object if it sits not tight enough).
4. Joining Plate for 3030 - 90 Degree place on the 3D print M6 Cap head Screw through the holes and fix from the opposite side with a M6 drop In T-slot
5. Attach to the ratchet and repeat for all other feet.

Information: make sure your 3D printer prints as accurately as possible because I didn't leave much wiggle room with the M5 Hex Locking Nut.