ordbot rumba mount plus fan

This provides all the mounting holes for the reprapdiscount "rumba" electronics board onto the ordbot hadron handle plate.

Note, I just published version7 (untested) They are intended to address the problems with the prior release (as follows) I have a have a few changes i want to make. I'm using this first version but it needs fixes...

1. The board mounting posts need to be about 1mm taller. I used some shim washers as a temporary fix. If you don't mind the nut-posts touching the component solder side wires (Don't use those holes) you can live with it as is. or use shim washers like I did.

1. The noles in the fan mount are too large. I intended them to self tap with m3 screws, but I ended up using longer screws and nuts to mount the fan to the thing. I also shimmed the 2 holes that hold the thing agains the panel with scrap extrustion string to...
   But I haven't gotten around to cleaning them up yet, and have had requests, so here they are as is....

   (i just added some shim washers in case you don't have any handy)

Print instructions

Category: 3D Printer Parts Summary

This provides all the mounting holes for the reprapdiscount "rumba" electronics board onto the ordbot hadron handle plate.

Note, I just published version7 (untested) They are intended to address the problems with the prior release (as follows) I have a have a few changes i want to make. I'm using this first version but it needs fixes...

1. The board mounting posts need to be about 1mm taller. I used some shim washers as a temporary fix. If you don't mind the nut-posts touching the component solder side wires (Don't use those holes) you can live with it as is. or use shim washers like I did.

1. The noles in the fan mount are too large. I intended them to self tap with m3 screws, but I ended up using longer screws and nuts to mount the fan to the thing. I also shimmed the 2 holes that hold the thing agains the panel with scrap extrustion string to...
   But I haven't gotten around to cleaning them up yet, and have had requests, so here they are as is....

   (i just added some shim washers in case you don't have any handy)