Fits well, even when printed with a crappy printer!
Aeropress travel adapter for original Aeropress
Enables the normal (non-travel version) of the Aeropress to be stored and kept together without harming the rubber seal.
54
296
8
2699
updated
October 17, 2023
Makes
Comments
Fits great, helps hold a nice stack of 20 or so filters.
Great print. I use it for travel and storage. A favorite small gift for other AP owners as well.
Any thoughts regarding adding a design for the XL?
@Spoony_77909 Glad you like it, and that it's worthy of gifting! I didn't even know there was an Aeropress XL, and I certainly don't have one to measure and fit. If you want to remix the model to make an XL version, please go ahead. I'll link it from here as well.
I'm no expert on settings and adjustments. Look up recommendations on stringing. More retraction, and there are other settings that get more detailed, but again, I don't really know a lot about it. There's also a setting that makes it prioritize moving within the body of the object rather than crossing empty space. In Prusa Slicer, it is under Print Settings>Layers and Perimeters>Avoid crossing perimeters. (edited)
i would love to have it with holes so air gets to the rubber if not 100% dry yet - will check it out anyways 👍
@hmchr_2203731 This part just holds the original screen on, out of direct contact with the rubber plunger face, so air can get in to dry it as long as it's not too wet.
@ReedBowman_53324 reading this again i have to apologize for my stupid comment 😂
Works amazingly well at keeping the filter holder without putting pressure on the piston.
Printed in Prusament Galaxy Black
An absolute most for every Aeropress owner
Works perfectly on my Aeropress and was a big big help during my last journey. Only needing hot water (coffee is in a lock&lock box), is a big win for coffee nerds! Thank you for making this available.
@cblte_447093 Glad it helps! It just seemed like a missing part of the device for as long as I owned it.
Thanks for this model. Perfect fit on my Aeropress.
Prusament PLA, 0.2mm, 3 perimeters, 15% infill.
Printed in PLA with my printer's default settings (0.2mm layer height, 15% infill).
I printed without supports, so it was a bit stringy when I took it off the bed, but it didn't affect the useability once I'd cleaned it up (I hate removing supports, so was happy that it worked without!).
Really neat solution, thank you :)
@isioviel Glad it was useful!