Wall Cable Entry Cover

Thanks again, I needed this to cover an unsightly hole next to each of my new garage lights. I scaled the model up to 150% and then lowered the height a bit so it wasn't so chonky/thick.

great build. i did have one attached from my broadband installation, until high winds took it off(obviously cheap adhesive used) the price for a replacement is rediculous so thanks for this.
Edit: I did this with PTEG first, and it was brittle, I realise the build isn't programmed for that. I increased the nozzle temp to 245° and bed to 79° for the first 2 layers. The picture of the grey ones are the PETG before and after. The shreds are off the first one. The other 2, black and white are PLA. They came out great.
A big thanks to the original modeller (edited)

Thank you for designing this and sharing it with others! I appreciate you :D

Your Welcome

This is a great little design, I ended up just drilling holes in it myself to secure it to the moulding.

I needed the cover slightly different sized but this works great once I shaped it in Cura, and will cover the unpained and wire coming out of the moulding untill we decide to replace out front door.

Thanks buddy!