Pool Accesory Holder for Deck Pole (skimmer nets and poles)

This pool pole holder is meant to help you organize pool pole based accessories vertically on a deck pole. It has spaced out holders for 3 poles and fits tightly to a deck pole.

Note Before Printing: 

• Please measure your deck post and pole accessories' diameter before printing.   Leave a comment if your measurements are different to the two below, and give me about a week to add a model to fitting your needs.  These are the two current models is made for:
  • Deck pool with a width of 3.5" and accessory pole diameter of 1.25", and
  • Deck pool with a width of 3.5" and accessory pole diameter of 1.00". 

Printing:

• The only test I've done was with PETG and 8 walls.  This generated a solid model.  PETG is flexible enough that even with a solid model, the pool accessory poles snap really well.  If you use a more rigid material such as ASA, you may have to use less walls (maybe 4) to allow flexibility (please let me know your results).
• No supports are needed if printed in the original STL configuration.  PETG with PEI plate didn't necessitate brims either.

Mounting:

• I mounted mine by flipping the print head-to-toes, but this is your preference.  Structurally, I think the way I mounted it makes a bit more sense.  This also allows a hard stop for the accessories.
• I used all 8 screws (8 holes) and used the shortest wood screw I had (1").  You might get away with just 4 screws (one on each side and two on the front).