This is a paper cartridge forming tool for 36. cal cap & ball revolvers. I looked around for a ready made model but couldn't find anything I liked and also most of them are for 44 cal.
This was roughly based on the cartridge formers from GunsOfTheWest but I designed it from scratch.
The tapered part is 25mm long and goes from 9.8mm to 8mm. ~~The hole at the top is 10x13mm which is around 15 grains~~
I printed them fine however I couldn't test them with powder so please report back on your experience.
Category: Sport & OutdoorsThe author marked this model as their own original creation. Imported from Thingiverse.