FT EMS V0.2 Rear Panel

INTRODUCTION

This modified rear cover for the Voron V0 was designed to address 2 issues: -

1. Allow more air in and out of the rear chamber
2. Complement EMS V0.2 from a design aspect

THE DESIGN

The design is a direct replacement for the rear cover so no additional screws are required. You will need the bigger fan which we currently support the 8010 and 92mm standard PC fans.

INSTALLATION

1. Attach the fan of your choice from the inside using the screws that work with the fan you are using. 
2. Remove the small fan that originally came with the V0 and plug the big fan in its place. You may need to cut the connector and install a JST.
3. DONE!

If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :)