GBS-C All-in-One (RetroScaler) Vertical Stand v2

This stand holds the GBS-C from AliExpress (blue plexi version) vertically. In this orientation, the component and VGA ports on the front are blocked, but the scart port on the side is accessible and is high enough off the table to allow most scart leads to fit normally. I designed this to minimize space at a vintage computer show where I used this scaler. It does not block or interfere with the color adjustment knobs.

This version solves the problem of the scaler sliding left/right in the stand by holding the blue RGB knob in a small notch in the stand. (Knob is still fully usable) It also adds 2mm additional height above the table for just a little bit more clearance for the scart cable. Uses a little more filament and takes about 20 minutes longer to print vs. my original design.

Suggest printing with 3 vertical perimeters so that the vertical portions are 100% infill for strength.