Creality Falcon 2 40w red laser alignment

Mounting bracket for Creality Falcon 2 40W. Allows you to add a red light laser to the Falcon 2 2 40W to allow easier alignment.

No addition screws or tape required to fit. It should be a nice secure push fit to the top of the laser housing.

Requires a 12mm diameter red light source

M2 nut & bolt to secure the laser into the housing

In Lightburn goto Edit/Device Settings. Enable “Laser Offset”.

You will need to work out your own offsets here. Mine are X: -51, Y: 0.9