Bike - Cateye rear light saddle rail mount - angled rails

I really liked my solution for Ergon Saddles, and copied the design over to the saddle rail interface from this solution BUT a design that wouldn't interfere with my saddle position being pushed totally forward like this one would.  So, this design sits on the angled portion of the saddle rails.

Only tested on a WTB Volt saddle. Most saddle angles will differ.

IMPORTANT NOTE:  PETG will creep, I suggest installing the mount, waiting an hour and checking again.

Requires Hardware:

• 2x M4x16mm bolt
• 2x M4 hex nut

Print Settings:

• Material: PETG
• Perimeters: ≥4
• Layer Height: ≥.2
• Support: YES, tree supports required.  See uploaded gcode for reference.
• Brim: Yes, see uploaded gcode for reference