Large Ice Cubes Mold Tray

NEW AND IMPROVED VERSION AVAILABLE HERE: https://www.printables.com/model/560982-customizable-large-ice-cubes-mold-tray

A mold to make giant ice cubes. The ice cube tray will produce 3 large ice cubes (150mm x 45mm x 45mm).

Fill the mold with food grade silicone - I used 30A silicone, using 15A to 60A shore hardness is recommended. Be patient when removing the cured silicone, you might want to use a fine blade to scrape the sides and separate the silicone tray from the mold.

Printed at 0.20mm layer height with two wall loops and 15% infill.

You will need about 325ml of silicone.

Make sure your printer is properly calibrated, the end plate holes have a very tight tolerance (0.05mm) You might want to adjust the hole compensation or do some post processing and enlarge the holes a little bit.  

I might upload a remix with easier tolerances and different ice cube sizes.

• I did :P see improved version below

NEW AND IMPROVED VERSION AVAILABLE HERE: https://www.printables.com/model/560982-customizable-large-ice-cubes-mold-tray

Thanks!