GreenHouse

A GreenHouse for seedlings.
A box with room for nine pots.
If you water a pot too much the water will spread to its neighbouring pots.

Print instructions

Printable for the Prusa Mini, maximum 180x180mm
Printed with PETG. It can get quite warm if you place it in a window and the sun shines at it. PLA can melt. Just telling...

Included GCODE files with PETG for both Prusa Mini and MK3S

(The preferred order of the files does not seem to work.
So I write the part names below.)

Parts:
Box
Pot

Two types of cover

Alternative 1.
A semi transparent lid with sunroof.
Printed this with Prusament PETG Clear on a textured sheet. Not optimal but quite cool :-) Don't have Clear filament? Use alternative 2 below.

Parts:
Lid
Hatch
HatchCave

Notes:
The greenhouse_lid.stl must be rotated 180 degrees
The greenhouse_hatchcave.stl must be standing with "supports on build plate only"
(as you can see in the slicer files)

Alternative 2.
Attachable bows. To be covered with a transparent plastic bag.

Parts:
Clip
Stick_Link
Stick

Notes:
The greenhouse_clip.stl must be rotated 90 degrees to it's side.
(as you can see in the slicer files)