Guitar and Bass X-frame Stand

This stand is designed to hold a solid-body guitar or bass, up to 50 mm in thickness (it doesn't fit acoustic guitars).

The x-frame makes it easy to assemble and disassemble so you can conveniently pack it when you are commuting.

My print settings:

• Infill 15% or more
• 3 layers top and bottom
• No brim (to maximize the printable surface)

Not mandatory: I have added small rubber pads for my slick and slippery floor and also on the apex of the stand to better hold my instrument + some felt where the guitar's body sits.

New: I have added a new version for the 250x250 print bed size as scaling up the model will affect critical dimensions that must remain unchanged. However, I haven't tested this one.