LOW POLY CAPYBARA

Downloaded model from https://sketchfab.com/3d-models/capybara-56845a31b9ec41f6b4124b9a7ecb64b8 and made low poly by self in Blender.

----------------------------------------------------------------------------------------------------------------

This cute capybara is the perfect print to show it off on your desk or even to your friends!

Print settings:

!Following settings only apply for the capybara model scaled down to Z = 40mm!

• Layer height: 0.16 - 0.28mm 
• Infill: 10 - 15%
• Supports: Touching Buildplate 
                    add support blocker on both eyes (.3mf file)
• Adhesion:  Brim or Raft
• Wall Ordering: Inside to Outside

Be careful when removing supports, you might hurt the capybara.