CR-10 S5 Adjustable Feet

I designed these to get a little elevation on the printer off the table it is on. Also to be able to level the printer. You can remove the current feet on the printer, install these and put those feet on the bottom of these, or get some M8x1.25 leveling feet and screw them into the bottom. I have a CR-10 S5 so I am not sure if they fit the other CR-10 models. If you have any suggestions for modifications please feel free to comment and I can incorporate some in and add them.

If you use M3 screws to hold on the feet. There is no need to drill the holes bigger where you take the original bumper feet off in the corners.

Parts I used: (not affiliate links)

M3 Cap screws

M8 x 1.25 adjustable feet with cushion https://www.mcmaster.com/6301K79

50mm feet shown in picture plus leveling feet.

Original Upload 9/22/2019

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: Any Any Any