BIQU B1 raiser + drawer mod

Designed to use a larger fan beneath the base of the printer !

Or, you know, just have a drawer.

I removed the 3 fans from inside the base, cut a huge hole and wired a 140mm Arctic fan outside the base, so it needed to be rose.

And here it is : 4 feets, still uses the rubber underneath, and a cute drawer to clean up your workspace.

All you'll need to install is :

1- remove existing feet

2- using the stock feet screws, screw the new feet in place

3- using smaller M3 screws, screw the stock rubber feet onto the 3D printed ones

4- If needed, cut a giant hole in your beloved printer

5- Tidy everything up, put the printer on it's workspace, and slide the drawer in place !

Congrats :-)