Swivel Trays for Honeycomb Storage Wall (HSW)

I saw a few different pivoting designs for stand alone and got inspiration from them.  I ended up designing this from scratch with OnShape.  I am still learning and there are a few more things I would like to do with this so expect some updates or a v2 in the future.

I'm all about options so I share that in this.  No supports are needed and I printed them in .24.  Mix and match from the options below to build out your desired arrangement.  Enjoy.

BOTTOM CONNECTOR: Optional heights of the tube and another set with a hole in the bottom.  The version with the hole is purely optional.  I made it because I had a plug get stuck in the tube and this would have helped me push if out.

• Tube Heights: This is the height of the tube on the outside.  Keep this in mind when you are mixing and matching trays/lids/spacers.  Sizes: 50mm, 75mm, 100mm, 125mm, 150mm.  150mm is shown in my picture.

TOP CONNECTOR: This fits in the tube of the bottom connector completing the connection to the panel.

TRAYS: I made a fair amount of them for your selection.  10mm - 75mm height in 5mm increments.  This is the outside height and what you would use when figuring out how many to fit on your bottom connector.

LIDS: Just a smattering of some covers.  Use them in between or at the top.  2mm, 3mm, 4mm, & 5mm available.

SPACERS: These are what they are.  Use them between or at the top/bottom.  1mm-10mm in 1mm increments.

PLUGS: These go in the tube before you put on the top connector.  They bring up the tubes internal bottom height if it is too deep.  I have also included half plugs if you want to mix it up.  If you have problems getting the plugs out I would recommend using the bottom connector with the hole.